Discussion in 'techPowerUp! Club Forum' started by SonDa5, Sep 26, 2009.
Somehow I'm liking how the tubing and the fan cable form this wave looking thing.
Chicken Patty despite all the other reasons, doesn't it look better in exhaust? You could try a shroud (⇇Fan⇇Shroud⇇H50⇇Fan) to further to increase CFM and remover dead air. This will also result in further drop in temperature.
I believe that is exhaust, I'm not positive though. I just remounted my TRUE and noticed that my fans (Yate Loons) blow air towards the side with the wires.
My H50 is exhausting at the moment.
idle like 30-32
Well, now that the TIM has cured a bit, here is the temps now with the case closed About a 8-9ºc over the Megahalem.
what tim was used?
The one that came with the Megashadow, Prolimatech's.
And silent right? What's your CPU vCore set at?
Here's is what mine currently looks like - waiting to get some new fans for the rad but these will work for now, and still need to let the as5 cure cause my temps are a little higher than I want.
Sorry for the crappy picture, can't find my camera.
I have a fan controller so it can be silent or full blast
The Phenom II 965 give a nice OC with low voltage.
Yeah they are not bad at all, it's a great CPU man.
Ordered CORSAIR Cooling Hydro Series CWCH50-1 120mm High Performance CPU Cooler
today from the egg. should ahve it by the end of the week.
Going on my 920 rig in my specs, but the case is changing. no longer Antec 300, Lian Li PC-K58W will be coming in with the cooler.
that should allow me to tri-Xfire my 4870s and be decently quiet as the stock i7 cooler is the loudest part right now.
question - do I have to use the Corsair* fan, or can I use any 120mm that fits? I couldn't tell if it was wired special or just a regular fan.
the corsair fan has a cpu fan connector
I notice everyone mounts this thing at wierd angles. Why not mount it right side up? You know so the Corsair logo reads right?
i have mine mounted so you can see the logo.
i have the cooler master storm scout (side panel is tinted) so i cant see it anyways
I have a 922 HAF I cant see mine ether but I was just wondering.
You mean Corsair fan right? Any fan will work.
That's a very nice-looking setup Chicken Patty. Well done.
here is my rig
30 minutes of prime 95
Any fan works, a few pages back you'll see some pics of mine with push and pull fans, both Scythes.
I can't turn mine enough for it to read right,
Separate names with a comma.