CPU-Z

[prescient]

no usb device sorry but here is the settings i changed and the rest is on auto

1. cpu core ratio to 45 x targeting 4.5 Ghz .
2. vcore 1.270 v .
3. Set min cache feq to 35 max cash Ratio to 42x .
4. cache voltage to 1.15v .
5. SVID - disabled .
6. eventual Input voltage to 1.79v hunter recommendation .
7. Asus multi core enhancement disable .
8. disable cpu spread spectrum .

Digi+ options:

9.Load Line Calibration to Level 6.
10.cpu power current 120%

 

[Ed_1]

no usb device sorry but here is the settings i changed and the rest is on auto

1. cpu core ratio to 45 x targeting 4.5 Ghz .
2. vcore 1.270 v .
3. Set min cache feq to 35 max cash Ratio to 42x .
4. cache voltage to 1.15v .
5. SVID - disabled .
6. eventual Input voltage to 1.79v hunter recommendation .
7. Asus multi core enhancement disable .
8. disable cpu spread spectrum .

Digi+ options:

9.Load Line Calibration to Level 6.
10.cpu power current 120%

ok ,which of these do you have and what value

fully manual mode =
CPU core voltage=
CPU core voltage override=

those should be all together , same section of bios .
PS: I am reading PDF manual .

 

[prescient]

CPU core voltage= it shows idle when am bios about 1. something
CPU core voltage override= 1.270 set and tested by me .

 

[Ed_1]

CPU core voltage= it shows idle when am bios about 1. something
CPU core voltage override= 1.270 set and tested by me .

CPU core voltage= should be a setting right above the CPU core override . Its default is auto , what do you have it set to .

 

[prescient]

manual

CPU core voltage= 1.270 this number is shown not set .
CPU core voltage override= 1.270

 

[Ed_1]

Ok, I don't know then , maybe someone else who has this MB will chime in .

 

[prescient]

there is a lot of screen shots on the internet





there when you chose cpu core voltage manual it gives you



there

Under this mode, the CPU will no longer be able to lower its CPU Vcore voltage when the system idles down even if the CPU Power Saving Schemes such as EIST or the various C-States are enabled.

i dont know but with multi coer enhancement disabled it dose idle
you guys think i should go adaptive ?

hi tj i am a bit confused about going adaptive
or not ..

i mean the cpu v core is idling but not the v cash is not .



am doing something bad by not going adaptive ?

i mean i can set it in 5 minutes just give me the values
if it makes any difference

i have vcore on 1.27 v
cash volt 1.15 v fixed

 

[rrrrex]

17.0.1.64 benchmark has weird behavior. If i set 1 thread it actually loads 2 threads. It makes single thread results lower than it should be. The new one (19.01.64) works fine. There are few screenshots for example:

Spoiler

Could you check that issue on your PC?

 

[maxfly]

Last post was 2014 bud. Time for a new thread