EK Water Blocks, Ljubljana-based premium water cooling gear manufacturer, is proud to introduce the full-cover water cooling solution for the GIGABYTE non-reference circuit board design WindForce 3X NVIDIA GeForce GTX 780 (Ti) series graphics cards. EK-FC780 GTX WF3 water block directly cools the GPU, RAM as well as VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and its VRM to remain stable under high overclocks. Base is made of nickel-plated electrolytic copper while the top is made of quality cast POM Acetal or Acrylic glass (depending on the variant). Screw-in brass standoffs are pre-installed and allow for safe installation procedure. The cooling engine uses refined, 0.6 mm wide microchannel structure to even further improve the heat transfer while not sacrificing the famous low hydraulic restriction design. Up to four EK-FC780 GTX WF3 series water blocks can be interconnected using various methods (EK-FC Terminal or EK-HD Tube & Adapter System) which allows for hassle-free piping job. The product is available in a single variant, an aesthetic retention backplate is also available: Products are readily available for purchase through EK Webshop and Partner Reseller Network.