GPU-Z incorrect GPU Clock and Bios not reading ...

[momothedog]

 

[erocker]

Please rehost the image. Try using www.techpowerup.org

 

[momothedog]

OK Rehost .. Plz check it ...

 

[cadaveca]

looks fine to me. Clocks are lower because the card is in low-power state.

BIOS version is listed.

 

[W1zzard]

http://gpuz.techpowerup.com/12/03/13/bqf.png

OK Rehost .. Plz check it ...

do you have the catalyst drivers installed? using remote desktop or anything like it ?

 

[brandonwh64]

Click on the ? mark next to the bus interface and run the render test, it should shoot up to default 3d clocks after that.

do you have the catalyst drivers installed? using remote desktop or anything like it ?

Also w1z have you though about moving the render test to a button on the main tab so everybody can test without looking for it? just wondering cause I took me stumbling apon the test by playing around.

 

[momothedog]

do you have the catalyst drivers installed? using remote desktop or anything like it ?

Catalyst 12.2 Driver From www.amd.com

 

[W1zzard]

looks fine to me. Clocks are lower because the card is in low-power state.

BIOS version is listed.

the first tab should show typical 3d clocks at any time

 

[W1zzard]

Catalyst 12.2 Driver From www.amd.com

let me grab that driver and check what's going on

 

[cadaveca]

the first tab should show typical 3d clocks at any time

Ah, I understand.

 

[momothedog]

let me grab that driver and check what's going on

Check ? ...

 

[W1zzard]

works fine for me. did you reboot after driver installation?

this result in gpuz only appears when it can't find a way to talk to the driver and falls back to reading real-time clocks (which it does in hardware without the driver)

 

[W1zzard]

this should be fixed in 0.6.0