Hello,
Just tried this with GPU-Z v0.7.8 and 0.8.3. The same observation applies to both versions.
I have a system with one Nvidia Quadro Z420 GPU for display and two Quadro K5200 GPUs being use for computations. Both K5200 cards are in TCC mode. GPU-Z shows accurate information for each card in the "Graphics Card" tab. However, the sensor data displayed even when a K5200 is selected appears to be the sensors from the K420. I can watch the utilization reported by the "nvidia-smi" command line go up to 99% in a K5200, but GPU-Z just reports the GPU Load from the K420.
Is there an issue with reading sensor data from a Quadro card in TCC mode?
Thanks,
---H
Just tried this with GPU-Z v0.7.8 and 0.8.3. The same observation applies to both versions.
I have a system with one Nvidia Quadro Z420 GPU for display and two Quadro K5200 GPUs being use for computations. Both K5200 cards are in TCC mode. GPU-Z shows accurate information for each card in the "Graphics Card" tab. However, the sensor data displayed even when a K5200 is selected appears to be the sensors from the K420. I can watch the utilization reported by the "nvidia-smi" command line go up to 99% in a K5200, but GPU-Z just reports the GPU Load from the K420.
Is there an issue with reading sensor data from a Quadro card in TCC mode?
Thanks,
---H