- Joined
- May 17, 2008
- Messages
- 405 (0.07/day)
- Location
- Bulgaria
I just got a new case today and when i was installing my HDD into the case i found that next to the sata cable connector on it there was a jumper that was configured to run the Hard disc at 1.5 Gb/s not 3 Gb/s as SATA II.
In the Seagate manual - http://www.seagate.com/staticfiles/support/disc/manuals/desktop/Barracuda%207200.11/100452348e.pdf in Section 3.2 there is an info about this but i didn't understand should i remove the jumper (because i already did ) or leave it there? Thanks
In the Seagate manual - http://www.seagate.com/staticfiles/support/disc/manuals/desktop/Barracuda%207200.11/100452348e.pdf in Section 3.2 there is an info about this but i didn't understand should i remove the jumper (because i already did ) or leave it there? Thanks