Discussion in 'General Hardware' started by wolf2009, Apr 6, 2010.
I need this
two pin to molex connector to power up the LEDs on the front fan on CM Sniper case.
Take a standard 3 pin fan connector and slice off one of the connectors to make it into a 2 pin connector.The pin spacing should be the same so it will fit fine.
The picture is wrong. Dont cut off the black that is ground wire. Cut one of other ones one is power other is for sensor wire for fan control.
I know,i only showed it to show how to do it,he can switch the pins around anyway to orient the red/black the correct way anyway.
You could also try this if it will work for you....
That would work too.
and if you want to do it somewhat decent
Though twisting some wires can work fine as well.
Separate names with a comma.