Hello all, new to RealTemp and just started trying some overclocking with no problems so far.
But, I read back through the documentation on the calibration and the Idle degrees above ambient section and wonder if my readings suggest some issues.
I haven't run the sensor test yet because I wanted to finish calibration first.
I have my BIOS set as directed and getting the following from both RealTemp and CPUIDHW.
My ambient is 24C sitting next to case.
Cores are 36-31-36-31 for a 12 degree delta.
Going by the text it seems that delta should be quite lower?. Should I investigate that before proceeding further?
Note I already ran a 3.6 OC and temps never pushed past low 40's on LinX but I wanted to get everything right in monitors before putting the OC back on.
These readings are from the initial Noctua install and CPU upgrade from May 2011 using AS5 on a P6X58D. Any curing should have been complete by now, but I didn't do a tear-off check when installing.
Thanks for any insight or suggestions.
But, I read back through the documentation on the calibration and the Idle degrees above ambient section and wonder if my readings suggest some issues.
I haven't run the sensor test yet because I wanted to finish calibration first.
I have my BIOS set as directed and getting the following from both RealTemp and CPUIDHW.
My ambient is 24C sitting next to case.
Cores are 36-31-36-31 for a 12 degree delta.
Going by the text it seems that delta should be quite lower?. Should I investigate that before proceeding further?
Note I already ran a 3.6 OC and temps never pushed past low 40's on LinX but I wanted to get everything right in monitors before putting the OC back on.
These readings are from the initial Noctua install and CPU upgrade from May 2011 using AS5 on a P6X58D. Any curing should have been complete by now, but I didn't do a tear-off check when installing.
Thanks for any insight or suggestions.