ch33sehead
New Member
- Joined
- Nov 18, 2006
- Messages
- 1 (0.00/day)
Okay, I'm running an x1900XT and I have a 2D profile that sets voltage to 1.175 and clocks to 500/600 and a 3D profile that sets voltage to 1.425 and clocks to 625/725. So, I set it so that when it detects 3D to detect the 3D profile, which it does. And I set it to revert back to the 2D profile when 3D application is closed.
So, when it tries to revert back to the 2D profile, it correctly loads the lower voltage settings but it does not load the 2D profile's lower clock settings! (Yes, I told the profile to save clock settings). So I try to do anything and the GPU crashes.
I have tried setting it to load default profile, but then it does not load the proper voltage settings since the default profile does not contain voltage information, so if I did that I would be running 500/600 on 1.425 voltage when I close the 3D application.
Any quickfixes anyone?
So, when it tries to revert back to the 2D profile, it correctly loads the lower voltage settings but it does not load the 2D profile's lower clock settings! (Yes, I told the profile to save clock settings). So I try to do anything and the GPU crashes.
I have tried setting it to load default profile, but then it does not load the proper voltage settings since the default profile does not contain voltage information, so if I did that I would be running 500/600 on 1.425 voltage when I close the 3D application.
Any quickfixes anyone?