[Case Gallery] Rev. 4

[ty_ger]

To view this case mod, go here.



Specs:
E8500 @ 4.27GHz
PC2-8500 HyperX @ 1,080MHz 4-4-4-12
8800GT SLI @ 700/1000
9400GT Physx
WD Raptor 150GB

Mods:
Made plexiglass side panel. Installed black drive bay insert. Cut motherboard tray holes for wire management. Installed water cooling system.

 

[tzitzibp]

basic mods.... superbly applied! 7/10

 

[kyle2020]

yo tiger, is that loop better than one way looping? i have one 12cm radiator and two 24 cm radiator, my old setup was pump->cpu->nb->vga->12cm->24cm->24cm->pump do you think better if i use the setup like urs but it's pump->cpu->12cm->nb->vga->24cm->24cm->pump, can u give me some suggestion . ^^

Id suggest a 24cm in between the CPU and the VGA.

 

[kyle2020]

Im not quite sure I understand what you mean? motorsport & air conditioner?

 

[t77snapshot]

Very clean case, great mod. 7/10

 

[ty_ger]

yo tiger, is that loop better than one way looping? i have one 12cm radiator and two 24 cm radiator, my old setup was pump->cpu->nb->vga->12cm->24cm->24cm->pump do you think better if i use the setup like urs but it's pump->cpu->12cm->nb->vga->24cm->24cm->pump, can u give me some suggestion . ^^

The loop has to be done on a case by case basis based on what hardware you have.

I chose to place the small 12cm radiator after the CPU because my GPUs run nice and cool. I placed the large 36cm radiator after the GPUs because my CPU runs a bit warm with the OC and I want to keep it as cool as possible. My CPU temps with IBT are 64c max temp and 56c max temp with Prime95 small FFTs.