I recieved me kit. The Water block for the CPU does not fit on a AM2 board, so had to use my existing mount. Took me 5 hours to install. The GPU block was also a pain as the under side where the screws where over lapped a resistor, so this wasnt good.
I managed to have the sinlge fan/radiator attached inside the case and have the reservoir inside also. The 2 fan/radiator sits outside the case. Nice little legs for it to sit onto. Aslong as ya have plenty space ofcorse. My Tower weighs that much the bottom shelf crumbled. So had to buy another desk and now sits on the top. I don`t like the analog speed controller being attached to the back. so kinda stuck that to me desk underneath infront. Makes it alot easier to adjust. So i don`t have to move far
As for temp specs, im well chuffed.
At stock Temp these were around 30c idle - 36c load.
With the water kit its now 22c idle - 27c load
Overclocking to 2.6 from 2.2 reaches temps no higher then 30c
GPU went down from 52c to 41c. But mem chips on the gfx have no heat sinks. so I need to have some kinda cooling on them apart from the intake and the side door fan.
Not happy that the cooling liquid only just passes the min line,I tried to use as little tubing as possible but would have been nice to see it at the max, instead I`ll have to spend another £10 to top up.
now just just need a Harddrive cooler and another VGA water block. Running outa space inside the case though. It will be like spaghetti junction. Its all Money money money. Me wife is already going nuts!
All in all. Im pretty impressed. So im a happy customer