Upgraded to 1050Ti, a couple questions

[Derek12]

Finally I got a 1050Ti to replace my 750Ti and games like Prey or ME:A seem to be smooth but I have two questions.

1. GPU-Z says almost constantly VRel while on load. Sometimes Pwr, sometimes both. With my 750Ti it never said VRel, but it said VOP, is it the same thing? I have searched but some says VRel means it's a weak PSU and other say it's because the voltage is not enough for boost (isn't that VOP???)

2. Again, with GPUZ always state Power consumption 47.X % TDP even on Idle, with my 750Ti it was a way lower value I know there is a thread about this and I assume it's a bad reading, right?

EDIT: Hwinfo also says 47.x TDP

EDIT 2: new question

3. GPU-Z says: GPU clock: 1291 MHz, Boost clock: 1392 MHz and default clocks are the same, but when in load, in the sensors tab, the GPU core clock is 1733 MHz, memory clock is normal. Other apps also say 1700 MHz approximately. What does this mean? is this a false reading?

Thanks

 

[newtekie1]

I'm not sure on the TDP issue, but I know seeing VRel is normal to see under load.

 

[P4-630]

When you see VRel your GPU is boosting to it's maximum speed which may vary on temperature, the lower the temp the higher the boost clock.

 

[peche]

When you see VRel your GPU is boosting to it's maximum speed which may vary on temperature, the lower the temp the higher the boost clock.

+1

also for monitoring i rather HWinfo, i run sensors only and check temps when possible...

 

[Derek12]

thanks for the replies
I edited the OP with another query

3. GPU-Z says: GPU clock: 1291 MHz, Boost clock: 1392 MHz and default clocks are the same, but when in load, in the sensors tab, the GPU core clock is 1733 MHz, memory clock is normal. Other apps also say 1700 MHz approximately. What does this mean? is this a false reading?
thanks again