Annihilator
New Member
- Joined
- Jan 3, 2008
- Messages
- 20 (0.00/day)
Processor | AMD X2 6000+ |
---|---|
Motherboard | Gigabyte GA-MA69G-S3h |
Memory | 2 GB |
Hi guys,
I just tried again to install windows vista. It just crashes when it finishes the installation. It reboots then it crashes with this error:
When I restart it it says: " Windows was rebooted. The installation can not be completed. Run the installation again".
I did, and it went out the same.
My system is : AMD x2 6000 with 2 Gigabyte ram. I already tried to run it with only one ram stick because somebody said it may be a ram problem. And somebody said I should check the timings, and make sure its on "auto". Well I cant find these settings in the bios, how exactly are they called?
Thank you, its really giving me headaches.
I just tried again to install windows vista. It just crashes when it finishes the installation. It reboots then it crashes with this error:
A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps:
Check to be sure you have adequate disk space. If a dirver is identified in the stop message, disable the driver or check with the manufacturer for driver updates. Try changing video adapters.
Check with your hardware vendor for any bios updates. Disable bios memory options such as caching or shadowing. If you need to use safe mode to remove or disable components restart your computer, press f8 to select advanced startup options and then select safe mode.
Technical information: ***Stop: 0x0000008E (0xC0000005,0xFFAB483D,0x8D453AE4,0x00000000)
Collecting data for crash dump...
Initializing disk for crash dump...
Beginning dump of physical memory.
Dumping physical memory to disk: 100
Physical memory dump complete
Contact your system admin or technical support group for further assistance
When I restart it it says: " Windows was rebooted. The installation can not be completed. Run the installation again".
I did, and it went out the same.
My system is : AMD x2 6000 with 2 Gigabyte ram. I already tried to run it with only one ram stick because somebody said it may be a ram problem. And somebody said I should check the timings, and make sure its on "auto". Well I cant find these settings in the bios, how exactly are they called?
Thank you, its really giving me headaches.