|Thermaltake TP-1500M Features & Specs|
|Max. DC Output (Peak)||1500W (1600W)|
|Efficiency||80 PLUS Silver|
|Operating temperature||0°C - 40°C|
|Protections||Over Voltage Protection|
Under Voltage Protection
Over Current Protection
Over Power Protection
Over Temperature Protection
Short Circuit Protection
|Cooling||135mm Dual-Ball Bearing Fan|
|Dimensions||150 mm (W) x 86 mm (H) x 220 mm (D)|
|Compliance||ATX12V v2.3, EPS 2.92|
|Price at time of review (exc. VAT)||$369.99|
The 1500W capacity classifies this unit among the strongest currently available on the market and the fact that it can deliver its max output power even with 115VAC power input automatically puts it in the "awesome" category. Equivalent to the high capacity are its weight and unfortunately its price. Also with 220 mm length you must first check before you buy it, if your chassis supports such a large PSU. Only 40°C continuous power rating is something we didn't like, since a high end PSU should be able to deliver full power even at 50°C. Finally the warranty is long enough at five years although some of the competitors provide seven years.
|Thermaltake TP-1500M Power Specs|
|Total Max. Power||1500W|
The unit outputs only (!) 1320W at +12V, a clear indication that conventional mag-amp post-regulators are used for the minor rails' generation instead of DC-DC converters. Speaking of the minor rails, their max combined power is ridiculously high for current needs. A contemporary system will never draw 280W from the minors, so it would be highly preferable to have an increased output at +12V and only 150-180W max combined power at 5/3.3V. Finally, with six whole Amps at 5VSB this beast won't have a problem charging two or more Ipads at the same time!
Cables & Connectors, Power Distribution
|ATX connector (600mm)||20+4 pin|
|8 pin EPS12V (600mm)||1|
|4+4 pin EPS12V/ATX12V (600mm)||1|
|6+2 pin PCIe (600mm+150mm)||4|
|6+2 pin PCIe (550mm)||4|
|4 pin Molex (550mm+150 mm+150mm+150mm)||8|
|FDD adapter (+100mm)||1|
There are lots of connectors and with eight PCIe you can power up to four high-end VGAs without any hassle. All cables are long enough with a minor exception: the modular PCIe cables where we would like to see an additional 50 mm length on each. The distance among the hardwired PCIe connectors and the modular peripheral/SATA ones is the recommended (by ATX spec). Finally the main ATX connector, along with all EPS and PCIe ones, uses thicker 16AWG wires while all others use 18AWG. We are very pleased to see thicker wires used in connectors that provide lots of current, especially in units of such high power levels, since the thicker gauges have less resistance resulting in smaller voltage drops with increased power outputs.
|12V1||ATX, Peripheral, SATA|
Power distribution is optimal since the two EPS connectors are fed through a dedicated rail while the PCIe connectors are equally distributed among the two strongest rails. However we think that 12V2, the rail which powers the two EPS connectors, should have at least 40A max power and not only 30A, in order to avoid unwanted OCP interventions if you use two EPS connectors and draw over 180W from each (rare scenario).