Recent content by Welshsteel

Can anyone crack this code the BSOD error message contained this: STOP: 0x00000024 (0x001902FE, 0xBACFBA7C, 0xBACFB778, 0xBA75554B) ftdisk.sys - address BA77554B base at BA749000 date stamp 3b798419 I've done a Google but i can't find this specific code. 0X00000024 problems seem to be...

Sorry i just noticed ... its meant to be 2 x 1gig ... and there rated at 1066Mhz so not really that much of an overclock.... ANYWAY as the first post states all my settings are now at stock!

OK it just crashed and hunge at a blue screen when i tried to close windows down the error reads: ftdisk.sys - address BA77554B base at BA749000 date stamp 3b798419

I am using a Sata power cable. The only other problems i have encountered is with fire fox - it occasionally shuts down. I have recorded the error and sent the report to Microsoft - there reply was completely useless - no help and no solution. Could it be the graphics card?

I've got a problem that i can't work out and need some help. THE PROBLEM - I have been getting about 1 BSOD a day for around 2 weeks now. The machine runs and is completely stable for hours. Call of duty 4 runs for 4 hours solid no probs, windows functions normally... then out of the blue the...

wasn't assuming it was Knoppix was just trying to get some other opinions... Thanks

Thanks Steevo... I don't understand what it did then. Before running Knoppix during the install of windows it would fail at the same point every time.... Even after cmos reset, hard disk re-format and a complete removal and then reinstall of all components..... I then loaded Knoppix which...

Yer frequencies are locked. Does anyone know what the bootable Knoppix (Lunix) did to make the windows install work. My guess is that there is certain on board memory functions maybe also corrupt files stored within the ram that are difficult to wipe? Bootable Knoppix (Lunix) loads...

What do you mean frequencies locked? I think the root of the problem is the fact that i installed windows while overclocked.

Ok i'm still with my first build which has been running smooth as you like for months until recently. I had my chip Overclocked to 3.8Ghz and this was prime95 stable around 14hours on the blend test. Cooling was fine temps during the small FFts occasionally creeped over the 70 mark but for...

Batmang the OCZ v2 will fit that motherboard if you configure the fan direction out of the back of the case. :) Echo75 that is the answer i was looking for, so the max temp you should allow the cores to go to is 72?

Cheers for your replys m8 :toast:

I knew that was the case.. Thanks for the beta... I might do 3dmark at higher clocks on both the GPU and CPU just for the sake of it to get a higher score:p and then lower them again... One thing i have noticed is that there is no massive increase in performance during game play between around...

thanks... with your water cooling rig... what do your temps hit at full load at 4ghz in comparison to the OCZ? Reason i ask is because i primed the other day at 4ghz (444 x 9) at 1.5 in CPUZ my temps were in the high 60's and low 70's during first 15mins! I've only had the Q6600 for a week...

ZenZimZaliben can i ask an of topic question.... How did you clock your MSI GTX so high??? Volt mod??