- Joined
- Aug 17, 2009
- Messages
- 1,585 (0.30/day)
- Location
- Los Angeles/Orange County CA
System Name | Vulcan |
---|---|
Processor | i6 6600K |
Motherboard | GIGABYTE Z170X UD3 |
Cooling | Thermaltake Frio Silent 14 |
Memory | 16GB Corsair Vengeance LPX 16GB (2 x 8GB) |
Video Card(s) | ASUS Strix GTX 970 |
Storage | Mushkin Enhanced Reactor 1TB SSD |
Display(s) | QNIX 27 Inch 1440p |
Case | Fractal Design Define S |
Audio Device(s) | On Board |
Power Supply | Cooler Master V750 |
Software | Win 10 64-bit |
I recently installed a new XSPC Rasa 750 RS240 kit on my system. It was cooling the CPU and IOH for about a week, but the goal was to add the GPU into the loop.
Everything was out of the case and power only applied to the pump and fans for a leak test.
Apparently I had not reconnected a hose to the IOH block tight enough. I turned it off immediately, but not quick enough to prevent blue fesser fluid (yes I know it's crap) running all over my board.
I've tried it the best I can. Going to check CPU, but think it's OK.
Questions are:
Do I need to do anything else?
Do I need to clean the board some how?
How long do I wait before trying the board again?
Where do I find someone to shoot me?
That is all.
Everything was out of the case and power only applied to the pump and fans for a leak test.
Apparently I had not reconnected a hose to the IOH block tight enough. I turned it off immediately, but not quick enough to prevent blue fesser fluid (yes I know it's crap) running all over my board.
I've tried it the best I can. Going to check CPU, but think it's OK.
Questions are:
Do I need to do anything else?
Do I need to clean the board some how?
How long do I wait before trying the board again?
Where do I find someone to shoot me?
That is all.
Last edited: