Foxconn 45cxm

[firehawk2]

Hi everybody,

I have foxconn 45cmx motherboard, when i power it on the POST card views : "no debug code" which means

the motherbord not running and i add another thing : when i put the red wire of multimeter to see the voltage that

should be 1.4 volt in the pin 7 of IC called APW7120 located near to ddr2 ram slot the motherboard shutdown

immediatly, i changed it but stillshutdown.

I hope that someone can help me, thanks.

 

[eidairaman1]

You're not providing enough information. What make snd model psu are you using? Do you have a panel switch hooked up.

 

[firehawk2]

Hi,

I use this POST debug card : http://www.sintech.cn/post card/st8678 PCI test card with LCD.html that shows me :"no debug

code" and i have PSU of 800w, i checked the output voltages of this psu and it works fine in another motherboards.

Thanks.

 

[eidairaman1]

Is the cpu in there? Good possible the bios chip is shot too. Unless if that test board is not compatible or faulty itself.

 

[firehawk2]

Hi,

The CPU is good, it was tested in another motherboard and it's ok.

The test boad is good because it was tested in many motherboards.

But I have seen some think : at pin 7 of IC APW7120 located near ram slot when I but red wire of multimeter on it and black wire on ground : the

motherboard shutdown immediatly.

any idea, thanks.

 

[eidairaman1]

Because youre shorting it out

 

[firehawk2]

But I test the same IC in another motherboard whithout problem.

 

[eidairaman1]

Replace the module or toss the board.