Recent content by AussieDave

the current settings I have at the moment: CPU-Z idle 0.984v Load 1.304v VID idle 1.0057 - 1.0107 v load 1.3561v CPU Level Up - 4.6G AI Overclock Tuner X.M.P Turbo Ratio - All cores mode (Adjustable in OS) Maximum Turbo Ration - ( Adjustable in OS) 46 Internal PLL Overvoltage-...

Sasqui I appologise for the late reply. I didnt realise it had been that long. Now I realise how long I been playing around with settings. It has well & truly done my head in. Yes, I did type the whole bios doc, untill I realised I could F12 & do screen captures, but then it bogs the thread...

Many thanks Kevin, I appreciate your reply. So all is ok & all good to overclock. thanks again

I would be greatful if you could do that... Maybe this information could be of some use to him. It is strange you are right. The cpu 100% load is only happening with my new maximus IV GENE-Z/GEN3 board. As shown in the last 2 screen captures. The last one was after a fresh install of windows...

Guys I greatly appreciate your input & your time taken in reading the doc file. @ Conflict0s I think the error message was something along the lines of having a power failure & that bios may have suffered damage. @ TheMailMan78. My system seems to have no issues & is working as it was...

ok, so this is strange... I just done a full format & reinstall of windows& pro 64bit. Updated all drivers & installed all windows updates. Ran the test & got the same cpu load results. I looked at the unusual sensor movement test. Core 3 being at 7. Is this right? As can be seen the...

Just run a new test. Same results, 100% cpu load through most of the test. I will now do a fresh install of windows & run the test again & see if things change

thanks burebista for your reply. I have the same programs running the background as I did in my first test. But, I agree with you about the CPU load. I noticed that also. I might run another test & see if it stays the same or changes. If the 2nd test stays the same with cpu load, I will do...

I appreciate anyone who can help out with my problem. As the subject says, I had 3 power failures in a row & on the 3rd failure, I got an error message about bios problems. I fear that damage has been done. I have gone to great lengths to write down all the bios settings in the hope that some...

I have no got rid of my old board & now have a new board. I did the same test with the new board. Room temp was 22 degrees C I would be greatfull for some thoughts on the results of my new board.

thanks BarbaricSoul the temps are very excessive. Admittedly my room temp was 28 degrees centegrade. I was curious to find out about the sensor movement test & the big differences in the cores & how to calibrate them. It would be interesting to see what your sensor movement test would look like...

in advance I wish to thank anyone who may have some input. It is appreciated. I have just run realtemp & prime to get an idea of how things are going. The temps are all over the place. I used prime with the blend function. Screen captures are as follows: If some kind person could...