Recent content by jeffeulogy

larger ID tubing allows for higher flow rate which directly affects cooling capacity.

you need to run the fully assembled loop without powering up the rest of the system. fill the reservoir, tilt the case to make sure some liquid is in the pump, and then uncap the res again. start the pump for a second by shorting the green wire on your psu's motherboard connector to one of the...

screw the kit. there's no substitute for a couple hours research into watercooling. if you want to go the high performance route then a custom loop will outperform anything you can overspend for through newegg. or if you want a budget setup just to eliminate some noise you'll make out much...

no, it's not compatible with the dothan or banias (pentium m). it's made for yonah (core duo) the ct-479 adapter will only work with socket 478 motherboards