GPU paste and thermal pads // Mboard z390 too

[Klemc]

My last wish is to repaste/repad my GPU...
... then when i want i can do it with my 4070-ti with ease (once trained all always becomes easier).

It lost 4<7°c when i applied MX4 to the chip, but this time i'll use MX5 and change the therm pads too.

3060XC : TPU review //\\ Paste and Pads

Thanks for advices. especially dimensions, i don't read same as what i view on photos !!

//

Also, i will have to do the Z390M-Plus Prime, motherboard, i search info about it for the pads thickness...

DIY : 6.5x1 cm + 7.5x1 cm
1mm ..? looks like !



SO :
120x20 (cut in two) Thermal Grizzly Minus

120x20 (cut in two) Gelid Extreme - my choice

ARCTIC TP-2 120x20 (cut in two)
ARCTIC TP-3 120x20 (cut in two)

Extreme Odyssey 120x20 (cut in two)

//

THERMAL PAD SIZES ON EVGA – GeForce RTX 3060 XC GAMING 12GB GDDR6 – THERMALPAD.EU

thermalpad.eu

VRAMs can be cut out: 80x40x2mm scissor
Set of three VRAMs #1: 40x15x2mm
Set of three VRAMs #2: 40x15x2mm
Set of two VRAMs: 25x15x2mm

The EVGA 3060 XC has two sets of three modules, each roughly is 40x15x2mm and has an additional set of two modules with size of 25x15x2mm.

//

For 3060XC :

2x2cm (1mm ?) backplate


2mm... what do you think ?:


ALL dimensions of GPU internals:


TOTAL (in cm) of GPU internals (backplate 2x2 is covered by mboard leftovers). Gelid Ultimate but i'll miss a tiny piece... will use mboard leftovers again

8x1.5
+
7x0.5
+
4x1

Paste :
MX6 for all.

Looks like good ?

 

[Pictus]

For the CPU/GPU

For the memory/etc

 

[Klemc]

For the CPU/GPU

For the memory/etc

Thickness matters ;p

So here i use paste instes pad :

MOBO

https://www.techpowerup.com/forums/attachments/20230514_202340-png.295894/

GPU

https://www.techpowerup.com/forums/attachments/gpuall-png.295933/

 

[Klemc]

GELID Ultimate for 3060XC Gaming (i'll paste GPU and remove PAD plastic then recover.