Monitors detected but no display

[KfcXMukbang]

Hi, I have 3 monitors, 2 msi optix g242 and an aoc 21inch. When I connect them up to my pc, all three of them are detected yet only the aoc monitor displays anything, I have reset windows, updated drivers, updated bios, reset bios and made sure my pc was fine aswell as the cables being fine. The monitors themselves are fine I would hope since they are brand new, they both boot up but show a vivid black screen as if they are on but just not displaying anything. I don't beleive it can be my GPU or anything in my PC since the aoc monitor works fine but the other 2 just simply do not display anything yet both are detected.

Any help would be really nice.

 

[Law-II]

For set-up instructions RX6600
Link: Setting Up and Configuring Multiple Displays to Run in AMD Eyefinity Mode | AMD

Note: as only two of the monitors have been detected by windows; Test each individually to ensure they work as intended by the manufacture (New out of the box dose not guarantee they will work)

 

[bug]

For set-up instructions RX6600
Link: Setting Up and Configuring Multiple Displays to Run in AMD Eyefinity Mode | AMD

Note: as only two of the monitors have been detected by windows; Test each individually to ensure they work as intended by the manufacture (New out of the box dose not guarantee they will work)

This. Try one monitor at a time to confirm they work individually. Then we'll look into how we can make them work together.

Fwiw, the monitor that is recognized as "Generic PnP" probably needs some drivers installed. But it should display something even without drivers.

 

[KfcXMukbang]

This. Try one monitor at a time to confirm they work individually. Then we'll look into how we can make them work together.

Fwiw, the monitor that is recognized as "Generic PnP" probably needs some drivers installed. But it should display something even without drivers.

Neither one of them works individually when I have tried and the monitor has drivers installed on it yet it still doesn't display anything

For set-up instructions RX6600
Link: Setting Up and Configuring Multiple Displays to Run in AMD Eyefinity Mode | AMD

Note: as only two of the monitors have been detected by windows; Test each individually to ensure they work as intended by the manufacture (New out of the box dose not guarantee they will work)

I have tested both on their own on my pc, neither worked.

 

[bug]

Neither one of them works individually when I have tried and the monitor has drivers installed on it yet it still doesn't display anything

There's your answer: they're dead/faulty.