• Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.
  • The forums have been upgraded with support for dark mode. By default it will follow the setting on your system/browser. You may override it by scrolling to the end of the page and clicking the gears icon.

Sapphire Pulse RX5700 BE problem flash bios

VtnXr22

New Member
Joined
Oct 1, 2023
Messages
12 (0.02/day)
Hello, I have a problem with uploading the BIOS to the cards after entering amdvbflash - and the test fails and I cannot upload the BIOS, only the amdvbflash version is 3.04+, I provide the information and the test runs successfully, but an error appears when I try to flash the cards. I've heard of a method to short-circuit pins 1-8 in the BIOS chip, but but I don't know if I can do it. Please help. The card works normally. If I made any mistake in writing, I'm sorry, my English is not very good
 

Attachments

  • Test fail.JPG
    Test fail.JPG
    18.6 KB · Views: 93
  • Failed to read rom.JPG
    Failed to read rom.JPG
    17.7 KB · Views: 90
  • Test pass.JPG
    Test pass.JPG
    22.2 KB · Views: 93
  • Error flash 3.04+.JPG
    Error flash 3.04+.JPG
    22 KB · Views: 90
Last edited:
Hello.
Please make more tests with the card.
If all the tests will pass then you have a fully functional card.
Remember that at the end of a flashing procedure, the program makes a CRC check.
It is more likely that the CRC failed cause some bit was not written corectly.
 
the card works well under load, does not turn off and so on

Is there any way to fix this?
 
Can someone send me the original bios for this card?
 

Attachments

  • Card.JPG
    Card.JPG
    17.9 KB · Views: 237
Would you be so kind and make some pictures (we already have the label) :
- GPU-z - main screen
- GPU-z > Adavanced Tab > and choose memory info
 
this what you mean?
 

Attachments

  • Gpu z info card.JPG
    Gpu z info card.JPG
    60.9 KB · Views: 74
  • Gpu z.JPG
    Gpu z.JPG
    29.1 KB · Views: 104
Unfortunately, the XT bios card gives a black screen when FurMark is temporarily loaded, so I will ask for a bios for the regular version. The bios was successfully flashed on Linux
 
Hello.
I searched BIOS-es that matches your card's spec.
You posted GPU-z main screen and there you have XT version written .
So i presumed that you have XT.
1696435380750.jpeg
 
I sent a photo and it says rx 5700 be and not xt and this gpu photo is just the bios flashed to xt which I managed to flash
 

Attachments

  • Card.JPG
    Card.JPG
    17.9 KB · Views: 63
I sent a photo and it says rx 5700 be and not xt and this gpu photo is just the bios flashed to xt which I managed to flash
The pic you posted at post #6 def says 5700XT.
 
We are glad that you've made it.
Cheers!
 
Back
Top