Hello, everyone.
I have a e8600 on p35-ds3 (f13 bios). I've set it on 4200MHz but for now all voltages are set to auto. Also i got four sticks of 1gb ddr2 ram on 840mhz.
The cpu voltage is 1.312 on idle and under stress goes a little down to 1.292v. Dimm's at 2.11v.
Just wondering if someone...
I recently bought this CPU.
It really easily went up to 4GHz and is very stable at that frequency.
When the CPU is idle its frequency is 2400 (400*6) and when is stressed it gets 4000 (400*10).
So far nothing peculiar.
But sometimes when the CPU is stressed with some heavy software program...
Is anyone playing the english version patched to 1.5.03 under Vista 64bit?
I cannot start the game under this OS. It keeps repeating something's wrong with remote access or control...
Ok, i put +0.1V on the NB (MCH) and now the Vcore is 1.248.
About the RAM voltages. When i open CPU-Z it says i have 1.8V but Everest says i have 2.11 (under DIMM section). Which one should i trust? :?
Ok. I've tried booting at 1.25Vcore at 4GHz but it couldn't. Should i touch the other voltages in order to make the cpu boot at that voltage? I'm not aiming at any higher than 4ghz.
Now the vcore is 1.312 and i think it's high :?
MCH is the north birdge, yes.
Everest shows that DIMM is 2.11V so i won't touch the ddr2 voltage.
Is 1.25Vcore for example suitable at 4ghz and should i touch the fsb, pci-e and the north bridge voltages?
The voltages i can change in the bios are as follows:
1)DDR2 Overvoltage Control
2)PCI-E overvoltage control
3)FSB Overvoltage Control
4)MCH overvoltage control - i think this is the north bridge voltage control?
5)CPU Voltage Control
Everything set to auto. I can't find the south bridge...
Hi.
I have a p35-ds3 board with four sticks of 4 gig supertalent cl4 memory and 8600. All my voltages in the bios are set to auto. What would be your recommendations to get the maximum of the cpu at 4 ghz. Especially i'm asking how should i change the voltages...