BIOS not showing after disabling CSM support. Using DP with Zotac RTX 3070 Ti OC cannot show bios screen, but enters windows fine.

[Niqui]

Hello there,

I am having an issue with my Zotac RTX 3070 Ti OC where I can not enter BIOS after disabling CSM Support. There is a reddit post on r/zotac about this, meaning this is a Zotac VBIOS issue.
You can read about the reddit issue there: https://www.reddit.com/r/ZOTAC/comments/w1cgis I am having the same issue. I just disabled CSM Support to enable Secure Boot, and after trying to go to BIOS, I dont see anything but a black screen.
I am requesting you to help me by sending VBIOS that works with this, as you did with the guy in the reddit post.

If you need anything else to make sure that its the right firmware for my card, I will be pleased to respond to you.

GPU SKU: ZT-A30710D-10P
ZOTAC GAMING GeForce RTX 3070 Ti Trinity
https://www.zotac.com/pa/product/graphics_card/zotac-gaming-geforce-rtx-3070-ti-trinity


PNPDeviceID
NVIDIA GeForce RTX 3070 Ti PCI\VEN_10DE&DEV_2482&SUBSYS_165319DA&REV_A1\4&2283F625&0&0019

SKU: ZT-A30710D-10P

also a video about a guy talking about this:

Basically I have to hope for ZOTAC to give me a fixed VBIOS to flash to my card I guess???

If you have any tips, suggestions, recommendations or you know a fix for this, please let me know.

 

[Caring1]

Did you even read the entire Reddit thread and take on board what was said?
Also TechPowerUp did not send anyone a "fixed" Vbios, they only have a repository for storage of Bios's.

 

[Shou Miko]

Many people forgets that not all DP monitors turn on after a reboot so you have to turn off and on the display again.

It's something that newer monitors do but older monitors need a power cycle but turning it off/on when you reboot or shutdown and start again I have a HP monitor on the work desk at work that does this.