Some people said that it's better than TRUE but HardOCP did a review and it is definitely not better. Again some said push pull config with Corsair H50 is better but they never test it against push pull TRUE. Any thought.
I watched the movie of the review that HardOCP did and IMO the way that it was configured was not optimum.
For optimum the case has to have good airflow and have a high CFM fan pushing cool air from outside of the case to the radiator with the Corsair fan pulling air way from the radiator.
I'm experimenting with my configuration and right now I'm getting much better temps running Prime95 than HardOCP did.
Also in HardOCP test near the end of the test HardOCP stated that his temps began to increase to high 90 degrees celsius.
I have not experienced that at all. Maby HardOCP had a bad pump or it was receiving a poor 12 volt feed.
In this test I was running push pull with my larger Scythe Fan pushing from inside the case like an exhaust and the Corsair 120mm PWm fan pulling the air away from the radiator. Over 7 hours heat building asmall FFT test starting at 8k though 64k test.
Note that one of my cores had an error after 2 hours and quit working but the rest of the cores kept going till i stopped the test approaching 8 hours of testing.
Also note that i was running 1.52 volts to a Quad Core Q9550. This is a huge amount of heat inducing voltage for that core. The temps reflect that the Corsair H50 did a fanstastic job of transferring the heat from the CPU.
If set up right the Corsair H50 performs better than air coolers and clears up the space around the CPU area for chipset cooling mods and improved airflow.