Didn't really know how else i could call this topic, this should do i hope. Back to question on hand - my dad bought a navigation (cheap one since in my country branded gps navigation devices cost way too much) and it is powered by Windows Embedded CE 6.0 At some point i decided to upgrade the navigation software/maps and was unable to as naviextras toolbox doesn't recognize my device at all, and to top it all it isn't even listed as a supported one. Either way i managed to get new software/maps. The only question i wasn't able to resolve is how can configure windows embedded ce 6.0 ? Thanks in advance. Any info is appreciated. Additional info on the device: Handhold Reference Board_A4 AT101A 6.0 Windows Embedded CE 6.0 105 MB RAm ARM1136JF-S AT550 480x272 Pixels, 65536 colors And i think it was made by sirfatlas.