- Joined
- Dec 20, 2010
- Messages
- 652 (0.13/day)
- Location
- Fresno, CA
System Name | LS Vtec B18B1 Bolt Ons |
---|---|
Processor | AMD Phenom ii 1045t x6 @ 3.5Ghz OC |
Motherboard | ASRock 970 Extreme3 R2.0 AM3+ |
Cooling | CM Hyper 212 EVO Push Pull |
Memory | CORSAIR Vengeance 8GB (2 x 4GB) Black 1600Mhz |
Video Card(s) | Sapphire 7950 Dual-X |
Storage | Samsung EVO 250gb SSD/Samsung 500gb 7200 rpm/WD Cavirar Green 1TB |
Display(s) | Acer H236HLbid IPS |
Case | NZXT Gamma (Powder Coated Champion White) |
Audio Device(s) | Creative Lab SB0460 |
Power Supply | NZXT HALE82 V2 550W |
Software | Windows 7 Ultimate 64bit SP1 |
Benchmark Scores | Vtec |
What you could do.... is cut cable management wholes and route the cables behind the motherboard Tray. You could then get grommet edging for the sharp edges on the wholes to give it a finished look.
You didn't do too bad for your first time. Everyone goes through a learning phase with this.
The other way if you don't want to cut wholes.... is to cable sleeve your power supply. Make the wires uniform and nice looking. If you can't hide them this will help!
Or just buy a cheap case with cable management wholes in it. They do sell them like this one.....http://www.nzxt.com/new/products/classic_series/beta_evo
About 30 Bucks but it will allow you to hide everything if your that concerned with it. Nice first job though bud way to go!!!
I wish I can cut the case, but it's a school project computer.