Discussion in 'Project Logs' started by t77snapshot, Dec 10, 2010.
damn that is a tight fit up there!! very nice
I am using Gelid's GC-Extreme compound and ready to mount the block.
The block has been clean internally and is looking sharp!....well as sharp as my crappy camera gets.
Man thats a sweet logo in there
posting to sub
That's pretty tight, but just right.
Very clean TIM install!!
Yes it is! What did you use to sprread it?
a credit card.
That is a very expensive "applicator"
oh right so I ran into a problem when I mounted the top rad, I couldn't screw down the back corner part of the top plastic bezel because the radiator is in the way of the screw holes.
I managed to find a plastic strap with an adhesive backing and stick it to the bezel.
I then drilled a hole so I could pull the strap tight and screw it down thus holding the top bezel down to the case. As long as I dont knock it around to much it should be fine.
I guess this could be in the ghetto mod section too.
Can I borrow it to spread some TIM too?
where will you mount the fans?on top of the rad?
lookin good so far
Top notch ghetto mod there.
Lets answer that with a picture
So, do the fans fit under the top panel then?
very nice T77, I want to see it finished.-
The second radiator (RX120) will be mounted in the front 5.25" drive bays. I will be using two Noctua NF-P12's as the push\pull fan config. I was originally going to use one Noctua and a stock CM fan but decided to use the stock fan elsewhere. I am trying to improve the acoustics on this semi-new build. Also using the clear tubing just for exact length cuts for when I get the black/ orange tubing.
Looks like there was some other jazz going on around the corner that you didn't take pics of.
Those are some spendy rad fans.
They are a bit more expensive than your run-of-the-mill variety, but they have a higher static pressure that makes them ideal for rads.
You're right. I was confusing them with the S12, which I have heard have poor rad performance.
Oh mi....sexy. Looking berry g00d home skallit!
/me Hunts fer da Subscribe button! :B
Lookin good man! What else needs to be done? You have all the rads pump and res and blocks mounted correct? Lets see some temps!
Separate names with a comma.