MKmods
Case Mod Guru
- Joined
- Feb 26, 2008
- Messages
- 5,697 (0.96/day)
- Location
- Nevada
System Name | Crossflow III |
---|---|
Processor | AMD 965 (4.04Ghz) |
Motherboard | Asus Crosshair III |
Cooling | Air |
Memory | 4 gigs Mushkin 7-7-7-20@1T |
Video Card(s) | single 9800GT |
Storage | Raptor 150's in Raid0 |
Display(s) | LG Flatron 24" |
Case | Custom |
Audio Device(s) | AuzenTech X-Raider W/OP637 |
Power Supply | Custom modded Corsair 750HX |
Software | Win 7 64/Solaris Utility |
Benchmark Scores | 3DMark06--21963 so far |
thanks DD.
OK now on to the FUN part... WIRING.
THIS IS THE KIDS DO NOT DO THIS AT HOME PART!
even unplugged the capacitors can hold a charge and zap you. (thanks DD)
(not to mention there goes the whole RMA possibility)
I am using a NorthQ 400 fanless PS (LOL, liars, there is a 70 mm fan on the inside)
(I would MUCH rather be using a Corsair 620 but this is the only PS I have)
First problem is where the wires exit the case, no grommet. They have rolled the edge but I just feel better knowing there is an extra layer of protection around the wires.
I cut a piece of the molding from MNPCtech (thinner than the Petras moulding)
One thing I notice about this PS is inside its BEAUTIFUL. I basically mod all my PSs and when I saw inside my Ultra (back before I knew better) there were multiple wires soldered to a single wire and parts looked messy, just junk compared to the NorthQ(nice job NorthQ )
I think I will sleeve the wires a bit more (looks cheap not going all the way to the inside)
OK now on to the FUN part... WIRING.
THIS IS THE KIDS DO NOT DO THIS AT HOME PART!
even unplugged the capacitors can hold a charge and zap you. (thanks DD)
(not to mention there goes the whole RMA possibility)
I am using a NorthQ 400 fanless PS (LOL, liars, there is a 70 mm fan on the inside)
(I would MUCH rather be using a Corsair 620 but this is the only PS I have)
First problem is where the wires exit the case, no grommet. They have rolled the edge but I just feel better knowing there is an extra layer of protection around the wires.
I cut a piece of the molding from MNPCtech (thinner than the Petras moulding)
One thing I notice about this PS is inside its BEAUTIFUL. I basically mod all my PSs and when I saw inside my Ultra (back before I knew better) there were multiple wires soldered to a single wire and parts looked messy, just junk compared to the NorthQ(nice job NorthQ )
I think I will sleeve the wires a bit more (looks cheap not going all the way to the inside)
Last edited: