AMD Rushes Out Catalyst 13.2 Beta 5 Driver to Correct 3DMark CrossFire Scaling Issue

[Akrian]

How old is your psu? Because i could see that your psu is more than capable of handling all of that load but maybe your psu is giving up. have you tried running prime95 and furmark at the same time? see if it crashes?

Couple of years old. Now it's only FC3 =) every other game and test runs fine ( I've found my issue with 3d mark too). FC3 just errors out after the logo. I've reverted back to 13.1 it works there, so it's a driver issue

 

[Rei86]

AMD's on a roll!

 

[HammerON]

Still can't get all three 7970's to work with 3DMARK
Two works fine...

 

[kn00tcn]

guys (dual & single), just put aticfx32.dll & atidxx32.dll from your good set into the folder where the game/3dmark exe is

you can have your boosted cry3 AND your working fc3 or blackops2 (here's a happy user)

arma2 is dx9 so atiumdag.dll in that case, http://benchmark3d.com/drivers-benchmark-table looks like 'beta4' gave arma a boost back to where it should be hanging (12.11 / 13.1 based sets were the drop)

dont forget to fill in the report forms

http://www.amd.com/report
http://www.amd.com/betareport
http://www.amd.com/mobilityreport

 

[Akrian]

Still can't get all three 7970's to work with 3DMARK
Two works fine...

Check if you have HPET enabled in bios. That did the trick for me

 

[Fluffmeister]

You could also try unticking "systeminfo hardware monitoring" on help tab.

 

[Initialised]

Odd, I'm getting ~6300 on 7970 and 11000 on 7990s, not 100% scaling but close enough. On a quad SLi 690 system I only got 6400 compared to ~9000 with one and 6100 with a single 680 so it looks like NVIDIA have more to worry about with mGPU scaling.

 

[TheoneandonlyMrK]

Same. I was getting lower scores on crossfire than on normal with 5870/5850.

I had a issue.
My hdmi audio went awol, it took realteks
Ati driver to ffix this