autior
New Member
- Joined
- Oct 7, 2011
- Messages
- 16 (0.00/day)
System Name | Yessir |
---|---|
Processor | Intel Sandy Bridge i5 2500k |
Motherboard | AsRock Z68 Extreme 4 Gen 3 |
Cooling | Stock |
Memory | 2 x Corsair Low Profile 4GB (1600Mhz) |
Video Card(s) | MSI 6950 2GB Twin Frozr 3 OC Edition |
Storage | Western Digital Black Caviar 750GB (7200 RPM) |
Display(s) | Philips 17" |
Case | Corsair 650D |
Audio Device(s) | On board |
Power Supply | Thermaltake Toughpower XT 775W |
Software | Windows 7 x64 Home Edition |
Hi, some months ago (6 months... not the fastest RMA service actually) I sent my VGA (MSI 6950 2GB Twin Frozr III Oc Edition) to my reseller because I was having problem with it, and after being repaired today I just got it again, but looks like I can't boot the PC when the VGA is inside. This is what happen:
Any advice would be appreciated, thanks.
- If I connect the monitor to the VGA, the monitor stay black without even reching the "Press F2 to setup" screen". The motherboard (Asrock Extreme 4 Gen3 Z68) show me the state b2, which is identified in the manual with: "Legacy Option ROM Initialization".
- If I connect the monitor to the motherboard's VGA while the 6950 IS still connected, I got the same problem as before: screen stay black and state b2 on the motherboard.
- If I connect the monitor to the motherboard's VGA while the 6950 ISN'T connected in the PCI-E, the PC runs as always did until now.
Any advice would be appreciated, thanks.