Hello,
I installed my ASUS X1900XT and cooled it with a Mach II GT and I have the following problem : the PC boots normally, the screen is displayed but as soon as the Mach II head temperature reaches about -40°C, the screen becomes light blue. In the Catalyst 6.2, the temperature indicated was 120°C, probably a bug temperature when it is too low.
Then when I waited a few quarters and restarted the PC, the graphic card worked but the phenomenon happened again.
For the insulation, I was very careful : nail varnish, seal string and neoprene or dielectric grease all over the graphic card and on the motherboard DFI Lan Party nF4 SLI-D.
I switched of the 2 following ATI services : ATI Smart and ATI Hotkey.
So, is it the cold bug which affects my card in particular ? Or a driver bug ?
I would appreciate your help very much.
Thanks.
I installed my ASUS X1900XT and cooled it with a Mach II GT and I have the following problem : the PC boots normally, the screen is displayed but as soon as the Mach II head temperature reaches about -40°C, the screen becomes light blue. In the Catalyst 6.2, the temperature indicated was 120°C, probably a bug temperature when it is too low.
Then when I waited a few quarters and restarted the PC, the graphic card worked but the phenomenon happened again.
For the insulation, I was very careful : nail varnish, seal string and neoprene or dielectric grease all over the graphic card and on the motherboard DFI Lan Party nF4 SLI-D.
I switched of the 2 following ATI services : ATI Smart and ATI Hotkey.
So, is it the cold bug which affects my card in particular ? Or a driver bug ?
I would appreciate your help very much.
Thanks.