- Joined
- Oct 6, 2009
- Messages
- 2,820 (0.53/day)
- Location
- Midwest USA
System Name | My Gaming System |
---|---|
Processor | Intel i7 4770k @ 4.4 Ghz |
Motherboard | Asus Maximus VI Impact (ITX) |
Cooling | Custom Full System Water cooling Loop |
Memory | G.Skill 1866 Mhz Sniper 8 Gb |
Video Card(s) | EVGA GTX 780 ti SC |
Storage | Samsung SSD EVO 120GB - Samsung SSD EVO 500GB |
Display(s) | ASUS W246H - 24" - widescreen TFT active matrix LCD |
Case | Bitfenix Prodigy |
Power Supply | Corsair AX760 Modular PSU |
Software | Windows 8.1 Home Primeum |
I just added a 2x140mm rad to my current WC set up. My set up before I added the Rad was....
XSPC Rasa CPU Block
EK 480 Rad (4x120mm)
2x MCW80 GPU Blocks
1x MCP655-B (No speed control but runs at 317Gph)
1x Swiftech Micro Res.
7/16 by 5/8 Tube
In order to fit the second rad in my case I had to install it with nozzles facing down vertically.While the EK 480 Rad on the back of my case is still vertical but nozzels are up.
My question is I have not got into too much testing yet but.... the temps seem a little worse then they were before. Is this too much for my Pump or would it be a better possibility that I did not bleed it all the way???
Suggestions???
Oh yeah if this helps....
Old order....
Pump>CPU>GPU>GPU>Rad>Res>Back to Pump
New Order
Pump>CPU>2x140 Rad>GPU>GPU>4x120 Rad>Res> Back to pump
Was getting temps Overclocked to 4.5 Ghz around 54c load and 44c load on the GPU (Overclocked to almost 1000mhz)
Now getting temps (Just backing up Steam) of around 47c CPU (Not overclocked) and 31c on the GPU (No load)
XSPC Rasa CPU Block
EK 480 Rad (4x120mm)
2x MCW80 GPU Blocks
1x MCP655-B (No speed control but runs at 317Gph)
1x Swiftech Micro Res.
7/16 by 5/8 Tube
In order to fit the second rad in my case I had to install it with nozzles facing down vertically.While the EK 480 Rad on the back of my case is still vertical but nozzels are up.
My question is I have not got into too much testing yet but.... the temps seem a little worse then they were before. Is this too much for my Pump or would it be a better possibility that I did not bleed it all the way???
Suggestions???
Oh yeah if this helps....
Old order....
Pump>CPU>GPU>GPU>Rad>Res>Back to Pump
New Order
Pump>CPU>2x140 Rad>GPU>GPU>4x120 Rad>Res> Back to pump
Was getting temps Overclocked to 4.5 Ghz around 54c load and 44c load on the GPU (Overclocked to almost 1000mhz)
Now getting temps (Just backing up Steam) of around 47c CPU (Not overclocked) and 31c on the GPU (No load)
Last edited: