Post your Cinebench R23 Score

[bigtimepower1]

 

[Eiffel]

 

[The King]

View attachment 263533View attachment 263534

Looks to be some thermal throttling at 47 all core? This was 4650 all core with an Air cooler. You may get a higher score with lower clocks try 4675 or 4650

 

[Eiffel]

Looks to be some thermal throttling at 47 all core? This was 4650 all core with an Air cooler. You may get a higher score with lower clocks try 4675 or 4650
View attachment 263539

before I could reach 4.9 ghz with 1.32v but for some reason when I try to reach 4.8 the pc turns off, it is most likely that the source has problems or the motherboard.
at 4.7 with 1.24v the maximum temperature in cinebench is 75 centigrade, I have it cooled with a MasterLiquid Lite 120 with two fans

 

[INSTG8R]

I am just smashing it now with my new "secret sauce" thanks to @Super Firm Tofu

 

[ir_cow]

ECO MODE 7950X - 90Watt peak

 

[Super Firm Tofu]

7700X - Stock with quick and dirty CO settings. Tuning to come later.

Single run:

10 minute run:

 

[tabascosauz]

It's kinda difficult to coax this 5800X3D to go faster. Obviously, power limiting and -30 all cores (-25 is stable, -30 hasn't crashed but not tested yet), but still figuring out the whole negative/positive Vcore offset thing, not as straightforward as it is on other Ryzen CPUs.

 

[gwynbleidd997]

1595 1T
12079 nT

5600X PBO CO -12 / -10 / -8 / -22 / -14 / -10 +200Mhz Fmax override (4.85Ghz 1T)
1X Scalar, 125 PPT, 75 TDC, 100 EDC
2x8GB 3600MT/s 16-18-18-38

Booted into safe mode for benchmarking. It does improve your scores quite a bit.

 

[QuietBob]

It's kinda difficult to coax this 5800X3D to go faster

Without altering the base clock the best you can achieve is about 1,500 ST and 15,200 MT. CO and top cooling are a must to even approach 15K in MT.

 

[INSTG8R]

It's kinda difficult to coax this 5800X3D to go faster. Obviously, power limiting and -30 all cores (-25 is stable, -30 hasn't crashed but not tested yet), but still figuring out the whole negative/positive Vcore offset thing, not as straightforward as it is on other Ryzen CPUs.

View attachment 263691

I’m jealous you’ve coaxed more out your RAM amd it’s stable. On my 5600X it easily ran 3800 but have zero luck above anything above stock and remain stable. I thought I had a bit r luck with some slightly tighter timings at 3600, benched fine but games were crashing so I knew it was a fail. Very nice score and I guess something I now have to shoot for but coaxing another 300,or so points out will be no easy challenge…

 

[tabascosauz]

Without altering the base clock the best you can achieve is about 1,500 ST and 15,200 MT. CO and top cooling are a must to even approach 15K in MT.

I'm not running top cooling anymore, so this is about as far as I go, just gonna do some corecycler for -30 and leave it. The full score was 1487 ST and 15097 MT. Of course I had to have HWInfo running to monitor so without HWInfo I reckon 1500 would've been in sight.

I’m jealous you’ve coaxed more out your RAM amd it’s stable. On my 5600X it easily ran 3800 but have zero luck above anything above stock and remain stable. I thought I had a bit r luck with some slightly tighter timings at 3600, benched fine but games were crashing so I knew it was a fail. Very nice score and I guess something I now have to shoot for but coaxing another 300,or so points out will be no easy challenge…

Don't get too jealous, I still can't boot 3800..........3800 daily stable on 2CCD and this 1CCD can't even boot ........part of me wants to believe I've just got some dud Fabric, part of me wants to believe Asus mucked up something major on the current BIOSes.

It's sure fast enough though, I reckon with the Vcache it might be a little less dependent on Fabric anyway. 5800X3D pretty bad on mem latency

I'll be honest, normally I'm around 14700 as well. The only thing I did was crank my 2000rpm fans up to max for the 15k.

 

[INSTG8R]

I'm not running top cooling anymore, so this is about as far as I go, just gonna do some corecycler for -30 and leave it. The full score was 1487 ST and 15097 MT. Of course I had to have HWInfo running to monitor so without HWInfo I reckon 1500 would've been in sight.



Don't get too jealous, I still can't boot 3800..........3800 daily stable on 2CCD and this 1CCD can't even boot ........part of me wants to believe I've just got some dud Fabric, part of me wants to believe Asus mucked up something major on the current BIOSes.

It's sure fast enough though, I reckon with the Vcache it might be a little less dependent on Fabric anyway. 5800X3D pretty bad on mem latency

I'll be honest, normally I'm around 14700 as well. The only thing I did was crank my 2000rpm fans up to max for the 15k.

Fair enough and yeah I had zero luck with getting the IF/RAM to cooperate at all on this new board. Heck it actually has a setting called "Memory Try Me!" yeah with the ! so my stock timings are 16-19-19-39 it offered me 16-18-18-38, well that seemed reasonable no? apparently nor..That was the previous method I used I mentioned.Nor did me attempting my same setup I ran on my 5600X which was just change CL16 to CL18 and set the RAM to 3800 and IF to 1900 NEVER had an issue ever...

I mean if Tofu( @Super Firm Tofu sorry bud didn’t mean to call you Taco)hadn't have pointed me to that Kombo Strike setting I wouldn't have gotten any gains at all...I mean I am on Water so while I find my temps are rather higher than I'm used too that Kombo setting has actually let it run cooler because as I understand it, its kind of a "PBO" and the Curve Optimizer combined. I tried an old fashion negative offset that gave me no gains either so I am just sticking with the Kombo setting alone and just take that as a win.
I do wonder what it would do with a legit 3800 kit but its so late in the game for DDR4 I don't feel like trying to find something decent only to find out it's not gonna work...

 

[Athlonite]

 

[Super Firm Tofu]

@kilo asked in the front page poll to see benchmarks at the various power levels so I decided to post them here if anyone is curious.


I'm in the middle of CO stability testing so these are at an all core -25 at the various PPT/EDC/TDC settings.

HWinfo was reset right before starting the benchmark, and screenshot taken as soon as the test ended.

Highlighted effective core clocks are what CB runs at at that power level with a-25 all core CO set.


105w TDP/142w PPT:

95w TDP/128w PPT:

65w TDP/88w PPT:

45w TDP/61w PPT:

Power choices within the BIOS for reference:

 

[Bzuco]

@Super Firm Tofu Insane perf/watt improvements over 5800x . Could be the voltage=>wattage even lower?
EDIT: my 11700f undervolted, cb23 14305 and 142W package after one run

 

[freeagent]

Bone stock, and quiet

 

[killerbyte]

1st bench 1st post <odd the images doesn't show...>

 

[Psychoholic]

7950X / DDR5 5600 -- Everything on Auto.
Was a little over 38K with my DDR5 6000, but its not 100% stable with that memory, so using the 5600.

 

[Det0x]

Domdtxdissar ST = 2167 points
Windows 10 x64 - AMD Ryzen 7 7950x | 16/32 @ ~6000mhz | ROG CROSSHAIR X670E HERO | 2x16GB DDR5-6200-28-36-36-28 1T

Domdtxdissar MT = 42257 points
Windows 10 x64 - AMD Ryzen 7 7950x | 16/32 @ ~5700/5400mhz | ROG CROSSHAIR X670E HERO | 2x16GB DDR5-6200-28-36-36-28 1T

Large custom watercooling loop. (4 pumps + MO-RA3 420 + NexXxoS Monsta Full Copper 400mm + 10L water among other things)

nevermind the "1.61" vcore, its a readout bug.. Highest voltage used was 1400mv.

@T4C Fantasy:
While your at it, maybe you can also update my final 5950x score ?

Domdtxdissar ST = 1726 points
Windows 11 x64 - AMD Ryzen 7 5950x | 16/32 @ ~5200mhz| MSI Unify X MAX | 2x16GB DDR4-3800-13-14-12-22 1T

Domdtxdissar MT = 33712 points
Windows 11 x64 - AMD Ryzen 7 5950x | 16/32 @ ~5050/4950mhz | MSI Unify X MAX | 2x16GB DDR4-3800-13-14-12-22 1T

 

[DJ8838]

1-6 cores 5,3GHz, 7-10 cores 5,2GHz. Actual voltage set to 1.325 and under load 1.375. Cooling corsair H170i, motherboard Asus prime z490p, memory corsair vengeance lpx 3600mhz. Final 3 minutes motherboard vr had some thermal throttling. Temperatures were about 80-85 degrees Celcius

 

[The King]

At the limits of my Air cooler. AIO should be coming soon!

 

[Nam-A-M-D]

My 5950x and asus formula x570 set as all core 4.7 scoring 30,940

 

[glnn_23]

7950x Custom water Ambient.

 

[DemonicRyzen666]

7950x Custom water Ambient.

View attachment 265029

you have your Fclk & uclk & memclk set to 1:2:2 ?
I think you might get a bum if yo uset 1:1:2