Hello, this is my 1st post here and i really like the forum, i have found lots of info.
I read some of the worklogs for case modding and the guides for window cutting but here is what i am really wondering:
I currently have a side panel with a window and i dont really like the design of it, i was wondering if i can take the window out and "fill" the hole that the window left with an aluminum sheet with my own window design and glue the sheet together with the side panel, i was thinking on using bondo but then i found that JB weld may do a better job, i am guessing i can still use bondo on the outside of the panel and sand it, have any of you guys done anything like this?
Thanks a lot any input would be appreciated.
I read some of the worklogs for case modding and the guides for window cutting but here is what i am really wondering:
I currently have a side panel with a window and i dont really like the design of it, i was wondering if i can take the window out and "fill" the hole that the window left with an aluminum sheet with my own window design and glue the sheet together with the side panel, i was thinking on using bondo but then i found that JB weld may do a better job, i am guessing i can still use bondo on the outside of the panel and sand it, have any of you guys done anything like this?
Thanks a lot any input would be appreciated.