- Joined
- Jun 24, 2013
- Messages
- 11 (0.00/day)
So, I'm having a weird issue with a Cisco switch. I am using Aerohive APs and they use different SSIDs that communicate over several VLANS. For some reason, they are only able to communicate over one SSID on one VLAN. It doesn't even recognize the others. It appears as though the ports on the switch are setup the same as other switches that also have those VLANS/APs. Has anyone else experienced this?
Here is an example of the configuration of an AP port:
switchport mode trunk
switchport trunk allowed vlan (lists VLANs allowed here)
switchport trunk native vlan (VLAN number here)
The VLANs themselves are also configured on the switch along with the helper IP addresses that correspond to them.
The switch is using VTP version 2 with the correct domain listed. The switch is showing that it was configured by the correct VTP server, but not since March.
Model: WS-C2960S-24PS-L
Anyone have any thoughts?
Here is an example of the configuration of an AP port:
switchport mode trunk
switchport trunk allowed vlan (lists VLANs allowed here)
switchport trunk native vlan (VLAN number here)
The VLANs themselves are also configured on the switch along with the helper IP addresses that correspond to them.
The switch is using VTP version 2 with the correct domain listed. The switch is showing that it was configured by the correct VTP server, but not since March.
Model: WS-C2960S-24PS-L
Anyone have any thoughts?