Build Quality
Overall build quality is mostly solid. When shaking the mouse, a loud rattle comes from the on/off-slider. When applying lateral pressure, no creaking but moderate flexing of the shell can be observed. Activating the side buttons by squeezing the sides is possible by applying excessive force. Lastly, accidental clicks when slamming down the mouse do not occur.
Main buttons on the Dash Ultra are good to very good. Pre-travel is low and post-travel is moderate, resulting in a fairly firm and snappy button response, though the right button appears more muted. Interestingly, the metallic "ping" commonly associated with Omron D2FP-FN2 switches is largely absent here. Being visually separated from the shell, button movement is low when provoked. Button stiffness is medium to light. A pair of Omron D2FP-FN2 (China) switches are used.
Side buttons are good. Pre-travel is very low, but post-travel is high to where the buttons can be pushed into the shell in their entirety. The actuation point is even across the entirety of these. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of seemingly unbranded 2-pin switches (white plunger) are used for these.
A button at the bottom is used for Bluetooth pairing. A seemingly unbranded tactile switch is used for this one. Cycling CPI steps is done by holding the left, right, and scroll wheel buttons pressed for three seconds. A slider at the bottom switches between 2.4 GHz wireless, Bluetooth, and off-state, which works fine.
The scroll wheel is decent. Noise levels are mostly under control, whereas tactility is basically nonexistent, as the individual steps barely have any separation. The encoder comes from TTC (blue, yellow core) and has a height of 11 mm. The middle (scroll wheel) click requires medium force for actuation. An elevated Huano switch (green plunger) is used for this one.
Surface
The Dash Ultra has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are no signs of wear left after doing so. All in all, excellent materials.
Disassembly
Disassembling the Dash Ultra is fairly easy. The screws are found beneath the front and rear skate. After removing those, five clips placed around the base and top shell also need to be dislodged, which may require wedging a credit card (or similar) in. Caution needs to be applied when separating the top and bottom shell to avoid ripping the cables connecting the two.
The internal design is efficient. The main and side buttons each sit on their own PCB screwed to the top shell and connected to the main PCB through an FPC. The battery sits on a sticky pad at the rear. Everything else sits on the very thin main PCB, which is affixed to the bottom with four screws. The MCU is a Nordic nRF54L15, whose datasheet can be found
here, along with a USB high-speed MCU marked as an Evision VS16D03A, which may be rebranded. Production date for all PCBs is the 52nd week of 2025, except for the side-button PCB, which has been manufactured during the 49th week of 2025.
As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.