Build Quality
Overall build quality is very solid. There is no rattle when shaking the mouse. When applying lateral pressure, no creaking or flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.
Main buttons on the RCC-1 are decent. Pre-travel is moderate and post-travel high, resulting in a rather muted and dampened button response. Being visually separated from the shell, button movement is minimal when provoked. Button stiffness is medium. A pair of Omron D2FP-FN2 (China) optical switches are used.
Side buttons are very good (forward button) to decent (back button). Pre- and post-travel are low on the forward button, whereas the back button has moderate pre- and post-travel, leading to a somewhat mushy button response, though the actuation point is even. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of 2-pin, low-profile switches from TTC (brown, blue plunger) are used for these.
At the bottom of the mouse are two buttons for cycling through the set CPI steps and available polling rates, both of which are stiff but otherwise work fine. A slider at the bottom switches between on and off-state, which also works fine.
The scroll wheel is very good. Noise levels are under control, and tactility is good, with each step being well-separated. The encoder comes from TTC (blue, yellow core) and has a height of 9 mm. The middle (scroll wheel) click requires high force for actuation. A Huano switch (blue plunger) is used for this one.
Surface
The RCC-1 has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are no signs of wear left after doing so. All in all, excellent materials.
Disassembly
Disassembling the RCC-1 is fairly easy. The screws are found beneath the front and rear skate. After removing those, seven clips placed around the entire base also need to be dislodged, which is fairly easily done by pressing against the bottom shell from the opening at the top. Caution needs to be applied when separating the top and bottom shell to avoid ripping the cables connecting the two.
The internal design is efficient. The side buttons sit on their own PCB screwed into the top shell and connected through a ribbon cable to the main PCB. The battery is stuck to the top. Everything else sits on the thin and reasonably compact main PCB, which has been affixed to the bottom with four screws. The MCU is a Nordic nRF52840, whose datasheet is found
here. The Bluetooth capability of the chip remains unused.
As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.