G-Wolves Fenrir Pro Review 15

G-Wolves Fenrir Pro Review

Sensor & Performance »

Build Quality

Overall build quality is very solid. There is no rattle when shaking the mouse. When applying lateral pressure, no creaking or flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.

Buttons


Main buttons on the Fenrir Pro are very good. Pre-travel is low and post-travel is very low, resulting in a firm and snappy button response. Being visually separated from the shell, button movement is low when provoked. Button stiffness is light. A pair of Omron D2LS-21 (20 M) switches are used.


Side buttons are excellent. Pre- and post-travel are minimal, and the actuation point is even across the entirety of these. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of surface-mounted Omron D2LS-21 switches are used for these.

A slider at the bottom switches between on and off-state, which works fine.

Scroll Wheel


The scroll wheel is very good. Noise levels are mostly under control, and tactility is above average, with the individual steps being reasonably well-separated. The encoder comes from TTC (black) and has a height of 4.5 mm. This one may be identical with the TTC E120 encoder. Of note is that the scroll wheel isn't fully inserted into the encoder. The middle (scroll wheel) click requires medium to low force for actuation. A seemingly unbranded tactile switch (black plunger) is used for this one.

Surface

The Fenrir Pro has a matte surface all over. Grip is fine, though the hexagonal pattern does attract fingerprints or dirt to an above average degree, and getting it fully clean again can prove difficult. All in all, good materials.

Button Sound Test


Disassembly

Disassembling the Fenrir Pro is easy. The screws are exposed, though in order to access the ones at the front, the main button pieces need to be screwed off. After doing so, the PCB can be removed from the shell without issue.

The internal design is highly efficient. The side buttons sit on their own PCB screwed to the top shell and connected to the main PCB through a ribbon cable. The battery sits on a sticky pad at the rear, and the sensor has been rotated by 90° to make additional room. The very thin main PCB is affixed to the shell with six screws, and has been extended such that it supports the structural rigidity of the shell. The MCU is a Nordic nRF54L15, whose datasheet can be found here, along with an unspecified USB high-speed MCU carrying the designation XUH32A405. Based on the device markings, it is likely a rebranded Artery AT32F405 using the QFN32 package, whose datasheet can be found here. The Bluetooth capability of the nRF54L15 remains unused.


As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.
Next Page »Sensor & Performance
View as single page
Nov 22nd, 2026 16:44 CST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts