G-Wolves Hati-S2 Pro 8K Review 1

G-Wolves Hati-S2 Pro 8K Review

Sensor & Performance »

Build Quality

Overall build quality is very solid. There is no rattle when shaking the mouse. When applying lateral pressure, no creaking or flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.

Buttons


Main buttons on the Hati-S2 Pro 8K are very good to excellent. Pre-travel is low and post-travel is very low, resulting in a firm and snappy button response. Being visually separated from the shell, button movement is low when provoked. Button stiffness is medium. A pair of Huano switches (green transparent shell, white plunger) are used.


Side buttons are very good (forward button) to good (back button). Pre- and post-travel are low on the forward button, yet on the back button, pre-travel is moderate, and post-travel high to where the button can be pushed into the shell in its entirety. Due to the resulting somewhat mushy actuation, the back button also ends up feeling stiffer than the forward one. The actuation point is even across the entirety of these. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of 2-pin, low-profile switches from TTC (brown shell, blue plunger) are used for these.

A slider at the bottom switches between on and off-state, which works fine.

Scroll Wheel


The scroll wheel is excellent. Noise levels are low, and tactility is great, with clearly defined steps allowing for controlled scrolling. The encoder comes from TTC (blue, yellow core) and has a height of 9 mm. The middle (scroll wheel) click requires medium to high force for actuation. A seemingly unbranded tactile switch (black plunger) is used for this one.

Surface

The Hati-S2 Pro 8K has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are no signs of wear left after doing so. All in all, excellent materials.

Button Sound Test


Disassembly

Disassembling the Hati-S2 Pro 8K is virtually trivial. All screws are exposed, which is why disassembly merely requires removing the screws holding the main PCB. Since two screws are found at the front under the main button pieces, these have to be removed as well, which is easily done as the PCB has cutouts around this area.

The internal design is highly efficient. The side buttons sit on their own PCB screwed to the top shell and connected to the main PCB through a ribbon cable. The battery sits on a sticky pad residing on the main PCB, and the sensor has been rotated by 90° to make additional room. The very thin main PCB is affixed to the shell with six screws, and has been extended such that it supports the structural rigidity of the shell. The MCU is a Nordic nRF52840, whose datasheet can be found here. The Bluetooth capability of the chip remains unused. Production date for the main PCB is the 20th week of 2025, whereas the side-button PCB has been manufactured during the 24th week of 2025.


As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.
Next Page »Sensor & Performance
View as single page
Nov 20th, 2026 14:33 PST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts