G-Wolves HTM Plus Review 3

G-Wolves HTM Plus Review

Sensor & Performance »

Build Quality

Overall build quality is very solid. There is no rattle when shaking the mouse. When applying lateral pressure, no creaking or flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.

Buttons


Main buttons on the HTM Plus are good. On the left button, pre-travel is low and post-travel is low to moderate, whereas on the right button, pre-travel is moderate to high and post-travel moderate, resulting in a fairly firm and snappy button response nevertheless. Being visually separated from the shell, button movement is very low when provoked. Button stiffness is medium to light. A pair of Huano switches (orange transparent shell, orange plunger) are used.


Side buttons are very good (forward button) to good (back button). Pre- and post-travel are low on the forward button, whereas the back button has moderate post-travel along with uneven actuation and lackluster feedback. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of surface-mounted Omron D2LS-21 switches are used for these.

A slider at the bottom switches between on and off-state, which works fine.

Scroll Wheel


The scroll wheel is good. Scrolling up in particular is fairly noisy, whereas tactility is above average, with the individual steps being reasonably well-separated. The encoder comes from TTC (blue, yellow core) and has a height of 9 mm. The middle (scroll wheel) click requires medium force for actuation. A seemingly unbranded tactile switch (black plunger) is used for this one.

Surface

The HTM Plus has a matte surface all over. Grip is fine, though the hexagonal pattern does attract fingerprints or dirt to an above average degree, and getting it fully clean again can prove difficult. All in all, good materials.

Button Sound Test


Disassembly


Disassembling the HTM Plus is easy. The screws are found beneath the front and rear skates, and after dislodging the seven clips arranged around the base, top and bottom shell are easily separated. When doing so, make sure not to rip the cable connecting the two.

The internal design is highly efficient. The side buttons sit on their own PCB screwed to the top shell and connected to the main PCB through a ribbon cable. The battery sits on a sticky pad at the rear, and the sensor has been rotated by 90° to make additional room. The very thin main PCB is affixed to the shell with four screws, and has been extended such that it supports the structural rigidity of the shell. The MCU is a Nordic nRF54L15, whose datasheet can be found here, along with an unspecified USB high-speed MCU carrying the designation XUH32A405. Based on the device markings, it is likely a rebranded Artery AT32F405 using the QFN32 package, whose datasheet can be found here. The Bluetooth capability of the nRF54L15 remains unused. Production date for the main PCB is the 33rd week of 2025.


As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.
Next Page »Sensor & Performance
View as single page
Nov 20th, 2026 14:19 PST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts