Build Quality
Overall build quality is very solid. There is no rattle when shaking the mouse. When applying lateral pressure, no creaking but slight flexing of the shell on the right-hand side can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.
Main buttons on the HTX Mini 8K are good. Pre-travel is moderate to low, whereas post-travel is low, resulting in a firm and snappy button response. Being visually separated from the shell, button movement is low when provoked. Button stiffness is medium. A pair of surface-mounted Omron D2LS-21 (20 M) switches are used.
Side buttons are very good (forward button) to good (back button). Whereas the forward button has low pre- and post-travel, post-travel is moderate on the back button, and the actuation point is not even across its entirety. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of surface-mounted Omron D2LS-21 switches are used for these.
A slider at the bottom switches between on and off-state, which works fine.
The scroll wheel is good to very good. Noise levels are somewhat elevated, but tactility is great, with clearly defined steps allowing for controlled scrolling. The encoder comes from TTC (brown, black core) and has a height of 5.5 mm. The middle (scroll wheel) click requires medium force for actuation. A seemingly unbranded tactile switch (black plunger) is used for this one.
Surface
The HTX Mini 8K has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are no signs of wear left after doing so. All in all, excellent materials.
Disassembly
Disassembling the HTX Mini 8K is moderately difficult. The screws are readily exposed, but dislodging the seven clips arranged around the base can be tricky. As always, wedging in a credit card or something similar is recommended, but finding a spot where it fits in can already be tough. When separating top and bottom shell, make sure not to rip the cable connecting the two.
The internal design is highly efficient. The side buttons sit on their own PCB screwed to the top shell and connected to the main PCB through a ribbon cable. The battery sits on a sticky pad residing on the main PCB, and the sensor has been rotated by 90° to make additional room. The very thin main PCB is affixed to the bottom with six screws, and has been extended such that it supports the structural rigidity of the shell. The MCU is a Nordic nRF52840, whose datasheet can be found
here. The Bluetooth capability of the chip remains unused.
As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws. However, there is some goo on a part of the main button pieces.