Build Quality
Overall build quality is solid. When shaking the mouse, a rattle comes from the storage compartment door. When applying lateral pressure, minor creaking but no flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do occur if debounce time is set to 3 ms or lower.
Main buttons on the A7 V2 Ultra are very good. Pre-travel is low and post-travel is high, resulting in a firm and snappy button response. Being visually separated from the shell, button movement is low when provoked. Button stiffness is medium to light. A pair of Omron D2FC-F-7N (100 M) (China) switches are used.
Side buttons are very good. Pre- and post-travel are low, and the actuation point is even across the entirety of these, resulting in pleasant actuation. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of surface-mounted Huano switches (white plunger) are used for these.
At the bottom of the mouse is a button for cycling through the set CPI levels, which works fine. A seemingly unbranded tactile switch is used for this one. A slider at the bottom switches between on and off-state, which also works fine.
The scroll wheel is decent to good. Scrolling is noisy, whereas tactility is above average, with the individual steps being reasonably well-separated. The encoder comes from TTC (blue, yellow core) and has a height of 9 mm. The middle (scroll wheel) click requires medium force for actuation. A Huano switch (white plunger) is used for this one.
Surface
The A7 V2 Ultra has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are no signs of wear left after doing so. All in all, excellent materials.
Disassembly
Disassembling the A7 V2 Ultra is easy. The screws are found beneath the front and rear skates, and after dislodging the clips arranged around the base, top and bottom shell are easily separated. When doing so, make sure not to rip the cable connecting the two.
The internal design is somewhat unusual. The side buttons sit on their own PCB screwed to the top shell and connected to the main PCB through a ribbon cable. The main button and scroll wheel switches, along with the scroll wheel encoder, likewise sit on their own PCB connected to the main PCB through a ribbon cable. This main button PCB has been affixed to a plastic assembly with three screws, which in turn is screwed to the top shell. The main PCB holds the remaining MCU and sensor, and it has a cutout for the scroll wheel. Five screws are used to affix the thin main PCB to the bottom shell. The battery sits on a sticky pad at the rear. The MCU is a Realtek RTL8762GKH, whose datasheet can be found
here. Production date for the main button PCB is the 33rd week of 2025.
As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.