NZXT Lift Elite Wireless Review 3

NZXT Lift Elite Wireless Review

Sensor & Performance »

Build Quality

Overall build quality is mostly solid. When shaking the mouse, a minor rattle comes from an indeterminable location. When applying lateral pressure, significant creaking but no flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.

Buttons


Main buttons on the Lift Elite Wireless are decent. Pre-travel is low and post-travel is moderate, resulting in a decently snappy button response. Being visually separated from the shell, button movement is high when provoked. Button stiffness is medium to low. A pair of TTC optical switches are used.


Side buttons are very good (back button) to excellent (forward button). Pre- and post-travel are very low, but compared to the forward button, feedback is lacking on the back button. The actuation point is even across the entirety of these. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of low-profile 2-pin Huano switches (white plunger) are used for these.

At the bottom of the mouse is a button which has different functions depending on how long it is pressed, which works fine. A seemingly unbranded tactile switch is used for this one.

Scroll Wheel


The scroll wheel is good. Noise levels are rather high, but tactility is good, as the individual steps are well-separated. The encoder comes from Kailh (black, red core) and has a height of 13 mm. The middle (scroll wheel) click requires high force for actuation. An elevated Huano switch (green plunger) is used here.

Surface

The Lift Elite Wireless has a slightly rougher matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are no signs of wear left after doing so. All in all, excellent materials.

Button Sound Test


Disassembly


Disassembling the Lift Elite Wireless is moderately difficult. The screws are found beneath the front and rear skates as well as a sticker right at the back. After removing all of those, the bottom shell still won't really budge. The four clips arranged around the sides keep the shell shut tight, and I had a hard time accessing them. I recommend manually disengaging the two clips towards the rear first, and then wedge a credit card or something similar in to disengage the others.

The internal design is far from efficient. The side buttons sit on their own PCB connected through a ribbon cable with the main PCB and clipped into an oversized plastic assembly, which also holds the battery. The needlessly large main PCB is moderately thin and affixed to the bottom with two screws. Two MCUs are used: an NXP LPC5516, which provides a USB High-Speed PHY and whose datasheet can be found here, along with a Nordic nRF52840, which handles wireless communication and whose datasheet can be found here. The Bluetooth capability of the latter chip remains unused. The production date for the main PCB is the 38th week of 2024, whereas the side-button PCB was manufactured during the 30th week of 2024.


As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.
Next Page »Sensor & Performance
View as single page
Nov 21st, 2026 01:17 PST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts