OCZ EL DDR PC-4800 Platinum Elite Review 0

OCZ EL DDR PC-4800 Platinum Elite Review

(0 Comments) »

Introduction

From the Manufacturer OCZ Technology:
  • 600MHz DDR
  • CL 2.5-4-4-10
  • 400MHz DDR (Dual Spec)
  • CL 2-2-2-5
  • Available in a 512MB module and 1GB (2x512MB) Dual Channel Optimized Kit
  • Unbuffered
  • Mirrored Platinum Copper Heatspreader
  • Lifetime Warranty
  • 2.8 Volts
  • 184 Pin DIMM
  • Tested to 2T, but may also run 1T on certain motherboards
  • EVP - use a VDIMM of 3.0V ± 5% without invalidating the OCZ Lifetime Warranty
  • ULN2 - Ultra Low Noise. Uses various printed circuit board (PCB) techniques to reduce the amount of electrical noise that is present in all high-speed ICs.
  • TCCD chips guaranteed
OCZ has released the PC4800 Elite Edition in reply to user's claims that their 4800 Platinum modules used Samsung TCC5 chips instead of TCCD. While TCC5 are, according to Samsung, a lower quality than TCCD, OCZ's in-house testing and binning did sort out only the better TCC5 chips for the 4800 Platinum modules. Since some users absolutely want TCCD and nothing else, OCZ guarantees that only Samsung TCCD chips are used on the PC-4800 Platinum Elite, but at a higher cost.

TCCD memory is known for being able to run high clock speeds, without needing as much voltage as Winbond's BH-5. Another advantage is that they do not get as warm during use, so active cooling is not required. Where BH-5 shines is very aggressive timings, 2-2-2-5 is very common. OCZ does offer to run the 4800 Platinum Elite at 2-2-2-5 timings too, but as our testing later shows, there is not much overclocking headroom, nor is there much gain from increased voltage.

Packaging


OCZ uses a blister pack, which can be opened without a knife, or injuries resulting from incorrect use of the knife.


Each module has a sticker on it, which gives the rated speed and the stock timings.


The memory heatspreaders are platinum colored. They are not really needed to keep the temperature of the memory down, it only gets hand-warm during operation, even when overclocked.
However, having a heatspreader sure helps protect the fragile components on the modules. If a stick falls down, there could be a chance that a small IC breaks off, not with this memory.
Last but not least a heatspreader is sure nicer to look at than the bare memory chips.

Test Setup

Test System
CPU:AMD Athlon64 3000+ Venice
Motherboard:DFI LanParty NF4 UT
Memory:2x 512 MB OCZ EL DDR PC-4800EL Platinum Elite
Video Card:ATI Radeon X850 Pro PCI-E
Harddisk:Maxtor Diamondmax 160GB
Power Supply:HEC PurePower 475
Software:Windows XP SP2, Catalyst 5.8

OCZ says the memory modules have been tested to run at 2T. We tested only at 1T since this is where the performance is. Why would you buy an "Elite" memory, and not run it at the fastest setting?

Our Patreon Silver Supporters can read articles in single-page format.
Nov 22nd, 2026 03:09 PST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts