Build Quality
Overall build quality is solid. There is no rattle when shaking the mouse. When applying lateral pressure, some creaking but no flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.
Main buttons on the X2 Crazylight are very good. Pre-travel is moderate to low and post-travel moderate, resulting in a firm and snappy button response. Being visually separated from the shell, button movement is minimal when provoked. Button stiffness is medium to light. A pair of FE optical switches with Pulsar branding are used.
Side buttons are very good. Pre- and post-travel are low, resulting in a pleasing button response, although feedback is less pleasant. The actuation point is even across the entirety of these. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of 2-pin, low-profile switches from TTC (brown, blue plunger) are used for these.
At the bottom of the mouse is a button for cycling through the set CPI levels, which works fine. A seemingly unbranded tactile switch is used for this one. A slider at the bottom switches between on and off-state, which also works fine.
The scroll wheel is good. Noise levels are slightly elevated, but tactility is quite good, with each step having decent separation. The encoder has Pulsar branding, but comes from F-Switch (blue, red core), and has a height of 9 mm. The middle (scroll wheel) click requires high force for actuation. A seemingly unbranded tactile switch (black plunger) is used for this one.
Surface
The X2 Crazylight has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are no signs of wear left after doing so. All in all, excellent materials.
Disassembly
Disassembling the X2 Crazylight is fairly easy. The screws are located beneath the front and rear skates. After removing those, five clips placed at the sides and rear also need to be removed, which may require wedging a credit card (or similar) in. Caution needs to be applied when separating the top and bottom shell to avoid ripping the cable connecting the two.
The internal design is highly efficient. The side buttons sit on their own PCB screwed into the top shell and connected through a ribbon cable to the main PCB. The battery is stuck to the bottom towards the rear. Everything else sits on the very thin and compact main PCB, which has been affixed to the bottom with six screws in total. The MCU is a Nordic nRF52840, whose datasheet is found
here. The Bluetooth capability of the chip remains unused. The side-button PCB has been manufactured during the 12th week of 2025, whereas the production date for the main PCB is the 10th week of 2025.
As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.