Rapoo VT2 Max Review 15

Rapoo VT2 Max Review

Sensor & Performance »

Build Quality

Overall build quality is solid. When shaking the mouse, a rattle comes from the top CPI buttons. When applying lateral pressure, minor creaking but no flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.

Buttons


Main buttons on the VT2 Max are very good. Both pre- and post-travel are low, resulting in a firm and snappy button response. Being visually separated from the shell, button movement is low when provoked. Button stiffness is light. A pair of Rapoo-branded optical switches rated for 120 million actuations (white plunger) are used.


Side buttons are very good. Pre- and post-travel are very low, and the actuation point is even across the entirety of these, though feedback is rather dull and hollow on the back button. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of surface-mounted Kailh switches (green plunger) are used for these.

At the top of the mouse are two buttons for cycling up and down through the set CPI levels, which feel fine. Another set of surface-mounted Kailh switches (green plunger) are used for these. A button at the bottom is mapped to a "DIY" function, which cycles through the available polling rates by default. A slider at the bottom switches between on and off-state, which also works fine.

Scroll Wheel


The scroll wheel is good. Noise levels are mostly under control, whereas tactility is above average, with the individual steps being reasonably well-separated. The encoder comes from TTC (blue, yellow core) and has a height of 13 mm. The middle (scroll wheel) click requires medium force for actuation. A seemingly unbranded tactile switch (white housing, purple plunger) is used for this one.

Surface

The VT2 Max has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is easy to clean, and there are virtually no signs of wear left after doing so. All in all, very good materials.

Button Sound Test


Disassembly


Disassembling the VT2 Max is easy. The screws are found beneath the front and rear skates. After removing those, four additional clips at the sides and front need to be dislodged, which is easily done. When separating top and bottom shell, make sure not to rip the cable connecting the two.

The internal design is unusual yet highly efficient. The main button switches, side-button switches, and top-button switches all sit on their own PCBs screwed to their respective locations in the top shell, and are connected through a single branching FFC. Everything else sits on the exceptionally compact and moderately thin main PCB, which has been affixed to the bottom with four screws. Two MCUs are used: a WCH CH32V305 GBU6, which provides a USB high-speed PHY and whose datasheet can be found here, along with a Nordic nRF54L15 for wireless communication, whose datasheet is found here. The Bluetooth capability of the latter chip remains unused. Production date of the main PCB is the 23rd week of 2025.


As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.
Next Page »Sensor & Performance
View as single page
Nov 18th, 2026 03:53 CST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts