ARYE RCC-1 Review 10

ARYE RCC-1 Review

Value & Conclusion »

Software


The RCC-1 comes with its own lightweight software. All options are accessible through three different tabs. The first page allows for button remapping to mouse, keyboard, media, and macro functions. The second page houses CPI adjustment settings for up to four color-coded levels, ranging from 50 to 32,000 CPI in increments of 50. Values can be put in directly by double-clicking the value instead of using the slider, and any non-native values are truncated to native ones. Also included are polling rate (1000/2000/4000/8000 Hz in wireless operation) and LOD (0.7/1/2 mm) adjustment options. The third page includes miscellaneous settings such as angle snapping (on/off). Sensor angle can be adjusted from -30° to 30° in increments of 1. Enabling "Boost Mode" will set sensor run mode to corded if corded mode is not already enabled and set sensor FPS to the maximum values of 20,500 Hz. "Ripple control" can be enabled to apply smoothing, which lessens jitter at higher CPI steps at the cost of increased motion delay. "Debounce Time" can be adjusted at a range of 0 to 20 ms in increments of 1 and effectively controls click latency. Furthermore, "MotionSync" can be turned on or off, which synchronizes SPI reads with USB polls at the cost of a motion delay penalty of up to an entire interval. "Auto Sleep" determines the amount of time needed to pass before the mouse will enter sleep mode, and can be adjusted from 10 seconds to 30 minutes.

All settings changes are saved to the on-board memory, so the software does not need to be running (or even installed) all the time. On my system, the software had a RAM footprint of 31 MB on average when running in the foreground, which doesn't change when minimized to the system tray. Upon exiting the application, all processes are terminated, as they should be.

Battery Life

ARYE does not cite any battery life numbers. The software features a percentage-based battery life indicator with single-digit accuracy, though its accuracy and reliability are strictly limited. For every two and a half hours of continuous usage at 8000 Hz with Boost Mode enabled, the indicator went down by roughly 15%, suggesting an expected battery life of around 15 hours when using these settings.

Sleep mode is entered after 60 seconds of inactivity by default, but this can be adjusted within the software.

Using the included USB Type-A to Type-C charging cable, I measured the charging speed during the constant current stage, which sits at 0.285 A when lifted and 0.274 A when not lifted. The battery has a capacity of 300 mAh (3.7 V) and utilizes a 3-pin JST connector.
Next Page »Value & Conclusion
View as single page
Nov 20th, 2026 15:21 PST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts