When copying games from your Steam Library, or other very large files (>10 GB), you may notice that write speeds on your SSD start at full speed, before dropping considerably. The underlying reason is that modern drives have small, fast caches, that soak up write bursts to improve performance. In the fairly uncommon scenario of writing data that's too big to fit into these caches, the drive will have to write data directly to flash, and it will probably juggle some out of its write cache at the same time, which can result in a significant loss of write speed. Newer TLC / QLC drives use part of their capacity in SLC mode for increased performance. This test can reveal the size of that pseudo-SLC cache.
The testing methodology used on this page simulates such a scenario. We write a sequential stream of 1 MB blocks to the drive in a single thread, like a typical file-copy operation would do, and measure write speeds twice a second. Please note that some other publications test this at higher queue depth, which will yield bigger numbers that are less relevant to real-world scenarios. The drive is fully erased before testing, to ensure any caches are emptied. This test generates a heavy write load with lots of data, something that most people don't do regularly—typical consumer workloads involve shorter bursts of write activity.
Write speed starts out at around 4.5 GB/s and holds there until roughly 300 GB have been written—that's the pSLC cache, and since every bit in SLC mode occupies three actual bits of storage, those 300 GB already eat about 900 GB of the drive's physical NAND, or 43%. At this point the SLC cache is full, and the controller is writing straight to TLC. It does that at a very impressive 3.3 GB/s, until the 1.3 TB mark, when all the flash is full and the controller has to fold pSLC data down into TLC before it can accept anything more, dropping the rate to around 1 GB/s. Filling the entire capacity averaged 2224 MB/s, which is a fantastic number for a Gen 4 SSD. Actually, this makes the NV7400 one of the fastest Gen 4 SSDs we ever tested with this specific workload, beating drives like the WD Black SN850X, the Hynix P41 Platinum and the Kingston KC3000, all of which have a DRAM cache, and far ahead of the Lexar NM790, which uses the same controller, but older flash.
As soon as the incoming stream of data stops, even for a few seconds, write speeds will be restored to full, because the SLC caching process has had some time to free up capacity in the background.