G-Wolves VUK Review 6

G-Wolves VUK Review

Sensor & Performance »

Build Quality

Overall build quality is solid. When shaking the mouse, occasionally a minor rattle comes seemingly from the scroll wheel. When applying lateral pressure, no creaking or flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.

Buttons


Main buttons on the VUK are very good. Pre-travel is low and post-travel is low to moderate, resulting in a firm and snappy button response. Being visually separated from the shell, button movement is very low when provoked. Button stiffness is medium to light. A pair of Huano switches (orange transparent shell, orange plunger) are used.


Side buttons are very good to good. Pre- and post-travel are low, though feedback isn't particularly pleasant. The actuation point is even across the entirety of these. Button size and placement are good, as actuation is possible rather easily by rolling one's thumb across. A set of 2-pin, low-profile switches from TTC (brown shell, blue plunger) are used for these.

A slider at the bottom switches between on and off-state, which works fine.

Scroll Wheel


The scroll wheel is good. Scrolling up in particular is fairly noisy, whereas tactility is above average, with the individual steps being reasonably well-separated. The encoder comes from TTC (blue, yellow core) and has a height of 11 mm. The middle (scroll wheel) click requires medium force for actuation. A seemingly unbranded tactile switch (cyan plunger) is used for this one.

Surface

The VUK has a matte surface all over. Grip is fine, though the hexagonal pattern does attract fingerprints or dirt to an above average degree, and getting it fully clean again can prove difficult. All in all, good materials.

Button Sound Test


Disassembly

Disassembling the VUK is virtually trivial. All screws are either fully or partially exposed, and after dislodging the eight clips arranged around the base, top and bottom shell are easily separated. When doing so, make sure not to rip the cable connecting the two.

The internal design is highly efficient. The side buttons sit on their own PCB screwed to the top shell and connected to the main PCB through a ribbon cable. The battery sits on a sticky pad residing on the main PCB, and both sensors have been rotated by 90° to make additional room. The very thin main PCB is affixed to the shell with six screws, and has been extended such that it supports the structural rigidity of the shell. The MCU is a Nordic nRF52840, whose datasheet can be found here. The Bluetooth capability of the chip remains unused. Production date for the main PCB is the 36th week of 2025, whereas the side-button PCB has been manufactured during the 31st week of 2025.


As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.
Next Page »Sensor & Performance
View as single page
Nov 20th, 2026 14:33 PST change timezone

New Forum Posts

Popular Reviews

TPU on YouTube

Controversial News Posts